Many are faced with a problem such as cracks on the ceiling in the places of connection of the plates. This often happens soon after the repair, which sometimes leads to a huge disappointment. Naturally a shame, it seemed that the repair was completed, there is furniture in the room, you are completely satisfied. But a little time passes and cracks appear on your ceiling. You begin to call those who made repairs, but it is impossible to get from them. Workers begin to refer to poor -quality materials and so on. But in most cases, the reason for everything is not the professionalism of people performing finishing work. So that there are no such misunderstandings, I advise you to contact trusted companies, a good example of which is a company that offer their services in the field of construction and finishing work. Let’s look at the correct way to close up the joints of the floor slabs (bells).
First of all, it is necessary to clean the entire ceiling from old coatings. Then, using the punch, you need to dissect completely the bells. After the ceiling is cleaned and the culbings are embroidered with the ceiling, it is necessary to primed the ceiling. After the primer dries (the drying time is indicated on the container), the joints between the plates must be sealed with facade glue. Not, in no case do not use gypsum plasters for sealing. After the facade glue dries, the bells must be primed again. Cut the net strips in advance under plaster 12-15cm wide. Stick a grid over the entire length of the seams using gypsum plaster. After the joints of the slabs completely dry again, the ceiling is completely again award and you can start alignment and putty. Do everything right and avoid unnecessary problems and disappointments.